Use and Care Manual

- 11 -
(Fig 1)
n USING YOUR PROLUX MIRAGE FLOOR BUFFER
Once you have the unit assembled, the correct pads installed, the water tank filled, and the battery charged;
you are now ready to use your Prolux buffer.
1. Switch the cleaner to either the “Scrubbing” setting to deep clean your floors, or the “Mopping” setting for
polishing and mopping your floors. (See page 6)
2. Press the Spray button to spray the water/solution mixture from the spray nozzle located on the base of the
unit, to treat the desired areas of your floor.
3. Once the desired area is properly saturated with water/solution, you will then run the unit over that area in a
smooth slow back and forth motion, until the area is clean.
n HOW TO CLEAN SCRUBBING PADS
There are multiple sets of cleaning pads that are included with your buffer, when they become dirty, you can
simply take them off the buffer, and wash them by hand in your sink with warm water and a mild detergent for
lightly soiled pads, or in your washing machine on a light duty cycle with mild detergent for heavily soiled pads,
and allow to air dry. DO NOT PLACE IN THE DRYER.
n CLEANING THE HOUSING
WARNING: Always switch off the appliance and disconnect it from the outlet before cleaning it. See section "Switching
Off and Retracting Power Cord.”
ATTENTION: Do not use Alcohol, cleaning or scouring agents to clean your machine, as these may damage the
appliance. Clean the outside of the housing using only a slightly damp washcloth.