!1 ! ! ! ! ! ! ! ! Prolux S7 7 in 1 Steam Cleaner Owners Manual
!2 ! ! Congratulations on your purchase of your new Prolux S7 7 in 1 Steam cleaner! The Prolux S7 Upright Steamer is designed to do 1 thing. Cut your cleaning time in half with no harsh chemicals! With a tool for nearly any job and up to 7 different functions it is designed to clean anything in your home. It is designed to instantly heat up (no heating wait time) which allows you to use it as your primary mop and floor cleaner. It also turns into a hand held steamer with a tool for nearly every job.
!3 ! ! ! Index Page Product Specifications …...................................................................................................3 Parts Description.........…...................................................................................................4 Safety Instructions.......…...................................................................................................5 Assembling the Unit ...…....................................................................................
!4 ! ! !
!5 ! ! ! ! Description of Accessories 1. Concentration Nozzle & Adapter Tool 2. Corner Attachment Nozzle 3. Scrapper Attachment 4. Floor Mop Pad x 2 5. Carpet Glider Attachment 6. Window Track & Tile Attachment 7. Nylon Brush Attachment 8. Upholstery & Garment Attachment 9. Copper Brush Attachment 10. Window Squeegee Attachment 11. Upholstery & Garment Attachment Pad 12.
!6 !Only use tap water. In hard water areas, we recommend that you use distilled water to prevent the formation of mineral deposits in the unit. !When replacing couplings on power cords or extension cords, the cord must remain water splash proof. Before using the device check it to make sure its in orderly condition and safe to operate. Especially check the power cord. !Do not steam any materials that contain Asbestos or that contain harmful substances. !Never use the unit as a toy.
!7 ! Assembling the Unit ! ! 1. Push the handle into main body until it clicks into place. 2. Push the main body down into the floor attachment until it clicks into place. 3. Put the hard water filter down into the main body (on the main body behind where the tank goes). The filter should be replaced every 6 months of use (see image below) . 4. Put the water tank down into the main body until it clicks into place. ! ! Filling the Water Tank ! ! 1. 2. 3. 4.
!8 NOTE: Upon first use of the steam mop or first use after refilling the water tank, the pump may make a “knocking” sound. This is normal and should only last a few seconds. While in use, the pump will continue to make a soft “knocking” sound. This is also normal. ! With the proper attachments attached correctly the user may begin steaming by pulling and holding the trigger.
!9 Use of the Accessories ! Floor Attachment (tool # 12) - The floor attachment on hard floor surfaces should be used with the Floor Mop Pad (#4 on the tool list above) on all hard floor surfaces. It is designed to be maneuverability and get around all hard to clean objects. ! Concentration Nozzle & Adapter Tool (tool #1) - The Concentration Nozzle & Adapter Tool is designed for those tough stains that need lots of steam pressure to remove.
!10 ! Step 1 – Spray steam evenly from a distance of 8 inches. ! IMPORTANT – Glass can rupture or crack if water is to hot or glass surface is to cold. cleaning glass always make sure glass surface is warm. Before ! Step 2 – Switch off the steam and use the Squeegee Attachment to wipe off the moisture moving from top to bottom. ! ! Filling the Water Tank During Operation! 1. Switch the steamer appliance off by releasing the trigger. 2.
!11 claim. When making a claim under the warranty, the proof of purchase (with purchase date) must be submitted. The warranty will not apply in cases of: - Non Normal wear and tear (example- commercial use) - Incorrect use, e.g. overloading of the appliance, use of non-approved accessories - Use of force, damage caused by external influences - Damage caused by non-observance of the user manual, e.g.
