Use and Care Manual

!
5!
Cord Connection
The vacuum runs on electricity, that means there is always danger of electric shock, so please observe the
following;
- Never touch the plug with wet hands.
- Always pull directly with the plug. If you want to disconnect the appliance from the outlet.
Never pull on the cord, as it might break.
- Take care that the power cord is not bent, pinched, rolled over or gets in contact with heat
sources.
- Use only extension cords suited to the power requirements of the appliance.
- Never immerse the appliance in water or other liquids.
- Only operate the appliance if your outlet voltage is the same as that indicated on the appliance's
nameplate. Using the wrong voltage can destroy the appliance.
- If the power cord of this appliance is damaged it must be replaced by the manufacturers, their
authorized service representative or a similarly qualified person to avoid danger to the user.
Never use a defective appliance or operate an appliance with a defective power cord. There is a major risk
of injury.
Unpacking and Assembling
Unpacking
1. Unpack the appliance and all its accessories.
2. Check that all the contents are included.
ATTENTION: Always transport or ship the appliance in its original packaging to avoid damage.
Recycle any no longer needed packaging material according as needed.
Assembly
WARNING: Only assemble the vacuum if it is not
connected to the electrical wall outlet.
1. Insert the end of the suction hose (fig.2)
into the intake opening of the vacuum cleaner until
it locks with an audible dick.