Use and Care Manual

Electric Power Nozzle used on Standard Prolux TerraVac Models

Operation

WARNING: Check the vacuum cleaner and the power cord each time before using it. A damaged

appliance must not be used. There is danger of injury.

ATTENTION: Only use the vacuum cleaner with all filters intact, in dry condition and correctly placed.

Make sure that the openings of the vacuum cleaner are not clogged or obstructed. Otherwise the vacuum

cleaner might be damaged.

NOTE: Your vacuum cleaner is equipped with a safety switch to prevent overheating. It automatically

cuts off the power supply if the motor is overheated. In this case, switch off the vacuum cleaner and

disconnect it from the outlet. Remove the cause of the overheating. Wait for about 45 minutes. After it

has cooled off, you may use the vacuum cleaner again.

Your vacuum is also equipped with a motor bypass valve. The purpose of this feature is if your vacuum

bag is too full, filters are too dirty, or if there is a clog in the vacuum the valve opens up. When the valve

opens up it allows air to enter in the motor chamber, reducing suction to the hose but making certain the

motor does not over heat and burn up. The Prolux TerraVac is a high end vacuum designed to last many

years. This feature protects the motor and allows it to be used for many years to come. When the motor

bypass valve opens up you will notice less suction and a different sound. When this happens turn the

vacuum OFF and unplug cord from electrical outlet. Then solve the problem by changing the bag,

filters or removing any clogs.

Vacuum Cleaning

1. Attach the desired nozzle. See section “Assembly” or

Using Further Accessories.”

2. Pull the power cord until the yellow marking is visible

(Fig. 10/1)