Use and Care Manual

pg.$7$

1. Change the dust bag: when the Dust full indicator turns to be red, it is time to clear the

dust or replace with a new bag. (Fig1)

2. Open the front cover by clipping. (Fig2,3)

3. Take out the bag holder then remove the full dust bag. (Fig4,5)

4. The motor protection filter should be removed and rinsed once a year, and can use it after

dry. If the filter is damage, a new filter should be replaced. (Fig6,7)

5. Wash or exchange the outlet filter (HEPA): clip down and remove the outlet cover by

hands for wash or exchange of filter. (fig8,9)

Warning

The plug must be removed from the power socket before any maintenance or replacement.

If the power cord is damaged, replace them only by the factory or maintenance center or

similarly qualified persons.

Troubleshoot:

Little or no suction

1. First make sure the adjustable suction control is turned all the way up. If there is

still little or no suction, check disposable bag or HEPA filter. If they are full, empty

them or replace them. If problem persists check for clogs in the hose and wand.

2. If blockage is found in the ground brush, hose or tubes, the machine can be

re-operated only after the blockage is cleared away.

3. Vacuum Lid will not close. Make sure bag is properly installed so lid can be