SDS

CETOL SRD RE NATURAL OAK SIK250-005
Product name
2.01
Product code
Date of issue
Version
00366007
25 January 2015
Composition/information on ingredients
3 .
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health or the environment and hence require reporting
in this section.
Linseed oil
8001-26-1
30 - 60
Solvent naphtha (petroleum), medium aliph.
64742-88-7
10 - 30
silicon dioxide
7631-86-9
1 - 5
Stoddard solvent
8052-41-3
0.5 - 1.5
Silica, amorphous, fumed, cryst.-free
112945-52-5
0.5 - 1.5
xylene
1330-20-7
0.1 - 1
2-butanone oxime
96-29-7
0.1 - 1
cobalt bis(2-ethylhexanoate)
136-52-7
0.1 - 1
1,2,4-trimethylbenzene
95-63-6
0.1 - 1
ethanol
64-17-5
0.1 - 1
ethylbenzene
100-41-4
0.1 - 1
Name
CAS number
% (w/w)
First aid measures
Eye contact
Skin contact
Inhalation
Ingestion
Notes to physician
:
:
:
:
:
4 .
Check for and remove any contact lenses. Immediately flush eyes with running
water for at least 15 minutes, keeping eyelids open. Seek immediate medical
attention.
Remove contaminated clothing and shoes. Wash skin thoroughly with soap and
water or use recognized skin cleanser. Do NOT use solvents or thinners.
Remove to fresh air. Keep person warm and at rest. If not breathing, if breathing is
irregular or if respiratory arrest occurs, provide artificial respiration or oxygen by
trained personnel.
If swallowed, seek medical advice immediately and show this container or label.
Keep person warm and at rest. Do NOT induce vomiting.
If ingestion, irritation, any type of overexposure or symptoms of overexposure occur during or persists after use of this
product, contact a POISON CONTROL CENTER, EMERGENCY ROOM OR PHYSICIAN immediately; have Material
Safety Data Sheet information available. Never give anything by mouth to an unconscious or convulsing person.
No specific treatment. Treat symptomatically. Contact poison treatment specialist
immediately if large quantities have been ingested or inhaled.
Use dry chemical,
CO₂,
water spray (fog) or foam.
Fire-fighting measures
Extinguishing media
Promptly isolate the scene by removing all persons from the vicinity of the incident if
there is a fire. No action shall be taken involving any personal risk or without suitable
training. Move containers from fire area if this can be done without risk. Use water
spray to keep fire-exposed containers cool.
Combustible liquid. In a fire or if heated, a pressure increase will occur and the
container may burst, with the risk of a subsequent explosion. Vapors may accumulate
in low or confined areas or travel a considerable distance to a source of ignition and
flash back.
Special protective
equipment for fire-fighters
Fire-fighters should wear appropriate protective equipment and self-contained breathing
apparatus (SCBA) with a full face-piece operated in positive pressure mode.
:
5 .
Special exposure hazards
:
Do not use water jet.
Suitable
:
Not suitable
:
Hazardous combustion
products
:
Decomposition products may include the following materials:
metal oxide/oxides
Flammability of the product
:
Page: 2/9
Canada - Mexico