isel=Vakuum UV exposure device Manual
I isel-Vakuum UV exposure device About these instructions In this instructions, you find different symbols marking important information for easy and fast reference. Danger Caution Reference Example Supplementary information ! A 0 co. iselautomafion 1999 All rights reserved In spite of every care, printing errors and errors can not be excluded. We welcome any suggestions and remarks on faults. &e/-machines and controllers are CE-conforming and adequately labeled.
isel-Vakuum UV exposure device Contents Safety note . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..~..................................................................... 3 1 Intended purpose .,............,................................................................................................ .4 2 Placement . . . . . . . . . . . . . . . . . . . . . . . . . ..*................................................................................
isel-Vakuum UV exposure device 1 Intended purpose The isel UV exposure device is suited for the light exposure of one-sided and/or doublesided printed circuit boards - up to micro run technology. Further application areas are the production of film copies, tampon printing cliches, front panel exposures and so forth. The exposure devices are designed for the application in dry rooms, schools, living and business areas, in laboratories and small firms.
isel-Vakuum UV exposure device 3.2 First commissioning 1. Connect the unit to 230 V mains. 2. Open the cover and activate the mains switch. A buzzing of the vacuum pump must be had hear. Within approx. 30 seconds, a low air pressure of approx. 0,4 bar must have built up (the film below the pressure screw is sucked onto the edition pane). Do not block the hole in the support pane if the pump is activated. It would be able to shatter due to low air pressure.
I isel-Vakuum UV exposure device Operating modes Second timer: If you turn on the device without pressing the rotating knob, the left number of the display shows the minutes and the other two numbers the seconds.
isel-Vakuum UV exposure device Time input 1. Turn you the knob to the left or to the right. The first display place (from the right) flashes. 2. Turn the knob step-by-step to the right. In the flashing display place, the value increases according to the rotary motion. Turn again to the left if the set value is too big. You can also turn to the right until the desired value is displayed again. 3. Press onto the knob to take over the set value (in no case, turn the knob simultaneously).
)-I isel-Vakuum UV exposure device 4 ( Abstract: Exposure of a double-sided printed circuit board - Creating the layout pocket 1. Attach thin double-sided adhesive tape onto a stripe of approx. 10 mm width of base material (I,5 mm). 2. Place the tool films (solder side and component side) identically on top of each other and glue base material between the tool films at one end. - Exposure 1.