300C Studio Flash OWNER’S MANUAL
Safety Precautions Specifications: 1. Before using the flash, make sure that your lighting equipment is plugged into a 110 volt AC power source. Do Power Supply: AC100 130volt 50/60Hz not use any power supply other than the AC specification Strobe output: 300WS indicated on your equipment. Guide No. (ISO100): 54m 2. Do not expose the equipment to sunlight, moisture, dust, dirt, rain or water. 3.
Light Body & Rear Control Panel (1) AC Power Supply Socket (2) Safety Fuse (3) Synch Cord Socket (4) General power supply on/off switch (5) Modeling Lamp on/off switch (6) Power setting for modeling lamp on/off switch (7) Recharge Ready-Light (8) Slave Sensor (9) Handle Grip (10) Audio signal for recharge ready on/off switch (11) Lock/Release Bolt for reflector & softbox connector (12) Test button (13) Output Power Setting for flash/ modeling lamp (14) Hand Wheel for angle adjustment (15) Stand Mount (16)
. 5. Synch Cord 9. Replacing flash tube Link the studio flash to your camera with a synch cord to Wear gloves whenever removing the flash or modeling lamp. trigger the light. You may also use the built-in slave sensor to When replacing the flash tube, first remove the modeling lamp, trigger your flash. then insert the flash tube. DO NOT TOUCH the anode OR Audio Signal cathode of the flash tube.
