User's Manual

Remote Flash Trigger Kit

Thank you for your purchase of a PROMASTER Remote Flash Trigger Kit. This

manual was written to help you get the most from wireless flash trigger. Be sure to

read this manual thoroughly before use.

The PROMASTER Remote Flash Trigger will fire your electronic flash unit from any

camera that has a hot shoe or PC outlet. The transmitter has a standard hot shoe as

well as a standard PC sync cable for cameras that do not have a hot shoe contact.

Both the transmitter and receiver feature a stand-by mode that saves battery power.

The wireless signal from the transmitter is encoded to help protect the unit from radio

frequency interference, ensuring that your flash unit fires only when you use the

trigger. The trigger has a test button which will fire the flash unit(s) without the need to

take a photo with your camera.

PAGE 1
Remote Flash Trigger Kit Thank you for your purchase of a PROMASTER Remote Flash Trigger Kit. This manual was written to help you get the most from wireless flash trigger. Be sure to read this manual thoroughly before use. The PROMASTER Remote Flash Trigger will fire your electronic flash unit from any camera that has a hot shoe or PC outlet. The transmitter has a standard hot shoe as well as a standard PC sync cable for cameras that do not have a hot shoe contact.
PAGE 2
Components Included: Remove the flash trigger kit from the box and confirm that you have all the items listed below. 1 pc. - Transmitter Code 5100 – 1 pc. Receiver Code 5107 – 2 pcs. Receiver Code 5100 – 2 pcs. AAA Alkaline battery Code 5107 – 4 pcs. AAA Alkaline battery 1 pc. - 23A Alkaline battery (pre-installed in trigger) 1 – pc.
PAGE 3
Replacing Receiver Batteries: 1. Turn OFF the receiver power 2. Remove the old batteries (AAA 1.5V or LR03 Alkaline batteries) 3. Insert two fresh batteries Using your Remote Flash Trigger: 1. Turn the power of camera and receiver OFF. 2. If your camera has a hot shoe, mount the transmitter to the camera hot shoe socket. If your camera does not have a hot shoe, connect the PC cable to the camera PC sync socket and to the transmitter. 3. Mount the flash on to the receiver shoe.