User's Guide

ACTIVslateXR User Guide
2
General Information
The radio version of the ACTIVslate is designed to work seamlessly with the
ACTIVboard or ACTIVhub and ACTIVstudio software. The ACTIVslate allows you
to control your computer from anywhere in the room by moving the ACTIVpen
over the ACTIVslate surface and using the ACTIVpen to perform mouse clicks on
the computer:
• Left click
Press the ACTIVpen on the ACTIVslate surface.
• Right click
Press the barrel button on the side of the ACTIVpen.
• Double click
Press the ACTIVpen on the ACTIVslate surface twice in
quick succession.
The ACTIVslate communicates with the ACTIVboard or ACTIVhub by radio
signals. When you use the ACTIVpen on an ACTIVslate, the information is
transmitted from the ACTIVslate via transceivers. The data is then sent, via
cables, to the PC and converted into mouse data.
Note: The correct driver software for your ACTIVboard or ACTIVhub must be
installed and working correctly on your computer. Refer to the ACTIVslate
Quick Start Guide for more information.
Up to 64 ACTIVslates can be registered with a single ACTIVboard or ACTIVhub,
but only one ACTIVslate can be enabled at any one time. The controller program
allows you to select the ACTIVslate you wish to use. The following pages
describe how to use the ACTIVslate and the controller program.
Compliance
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications to this equipment not expressly approved by
Promethean may void the user’s authority to operate this equipment.