User manual

SATA150 TX2plus, TX4 User Manual
6
Figure 2.
SATA150 TX2plus Controller card.
4. Attach one Serial ATA data cable to each hard drive. Then attach the other
ends of the cables to one of the Serial ATA ports on the SATA150 TX2plus
card. All of the connectors are keyed so they will only attach one way.
Note
The SATA150 TX2plus Controller card is a PCI Plug-n-Play
(PnP) device. No changes are necessary in the Motherboard
CMOS Setup for resources or drive types in most applications.
Serial ATA
Port 2
Parallel ATA
Port 3
Serial ATA
Port 1
LED
Pins
Pin 1–Blue
Connector