User manual

Chapter 2: Getting Started
7
SATA150 TX4
The SATA150 TX4 Controller card supports up to four Serial ATA hard drives.
6. Install all of the hard drives into the hard drive bays of your system,
including their power cables.
7. Attach one Serial ATA data cable to each hard drive. Then attach the other
ends of the cables to one of the Serial ATA ports on the SATA150 TX4
card. All of the connectors are keyed so they will only attach one way.
Figure 3.
SATA150 TX4 Controller card.
Note
The SATA150 TX4 Controller card is a PCI Plug-n-Play (PnP)
device. No changes are necessary in the Motherboard CMOS
Setup for resources or drive types in most applications.
Port 3Port 1Port 2Port 4
LED
Pins