User manual

SATA150 TX2plus, TX4 User Manual
18
New Windows NT4.x Installation
The following details the installation of the SATA150 TX Series drivers while
installing Windows NT4.x.
1. Start the system installation by booting from the Windows NT disk:
• Floppy install: boot the system with the Windows NT installation
diskettes.
• CD-ROM disk install: boot from the CD-ROM disk and press F6 when
the message “Setup is inspecting your computer’s hardware
configuration…” appears.
2. When the Windows NT Setup window is generated, press S to Specify an
Additional Device(s).
3. Select Other then press Enter.
4. Insert the SATA150 TX Series driver diskette into drive A: and press Enter.
5. Choose WinNT Promise SATA150 TX Series Controller from the list that
appears on screen then press Enter.
6. The Windows NT Setup screen will appear again saying “Setup will load
support for the following mass storage devices:” The list will include WinNT
Promise SATA150 TX Series Controller.
NOTE: If there are any additional devices to be installed, specify them now.
When all devices are specified, continue to the next step.
7. From the Windows NT Setup screen, press Enter. Setup will now load all
device files and then continue the Windows NT installation.
8. After a successful installation, the SCSI Adapter Setup box will show that
the WinNT Promise SATA150 TX Series Controller driver has been
installed.