User manual

Chapter 3: Installing Software Drivers

Existing Windows NT4.x Installation

The following section details the installation of SATA150 TX Series drivers on a

system that has Windows NT4.x already installed and running.

NOTE: Do not attach the boot drive or any other hard drive to the SATA150 TX

Series controller card before completing this step.

1. From the Start menu, choose Settings.

2. From the Settings menu, choose Control Panel.

3. Double-click the SCSI Adapters icon. The SCSI Adapters dialog box

appears.

4. Choose Drivers then click Add.

5. In the Install Drivers dialog box, click Have Disk…

6. When Install From Disk appears, insert the SATA150 TX Series driver

diskette in drive A:.

7. Type A:\NT4 in the text box window then click OK.

8. When the Install Driver dialog box appears, select WinNT Promise

SATA150 TX Series Controller then click OK.

9. When the Select SCSI Adapter Option dialog box appears, click Install.

10. After a successful installation, the SCSI Adapter Setup box will show that

the WinNT Promise SATA150 TX Series Controller has been installed.

11. Power off your system.

12. If you plan to move the boot drive to the FastTrak card, connect the boot

drive to the FastTrak card now. Power on your system.

Removing the Driver from Windows NT4.x

1. From Start, choose Setup then choose Control Panel.

2. In Control Panel, choose SCSI Adapter then choose Drivers.

3. Click the Remove button.

4. After successful removal, the SCSI Adapter Setup box will show that WinNT

Promise SATA150 TX Series Controller has been removed.