User manual

Chapter 3: Installing Software Drivers
21
Existing Windows 98 Installation
The following section details the installation of SATA150 TX Series drivers on a
system that has Windows 98 already installed and running.
1. After installing the SATA150 TX Series controller card and configuring the
hard drives, power up the system and boot Windows.
2. The “Add New Hardware Wizard” will appear, informing you that it has
found a “PCI Mass Storage Controller.”
3. Click Next. From the generated list box, choose Search for best driver for
your device (Recommended).
4. Insert the SATA150 TX Series driver diskette in drive A:.
5. Click Next. From the generated choices, choose Specify a location.
6. Type A:\WIN98-ME in the text box that appears.
7. Click Next. A message informing you that Windows has found “Win98-ME
Promise SATA150 TX Series Controller” should appear.
8. Click Next, then click Finish.
9. Click Yes when asked if you want to restart your computer. Be sure to eject
the diskette from drive A:.
Confirming Driver Installation in Windows 98
To confirm that the driver has been properly loaded in Windows 98, perform the
following steps:
1. Choose Settings from the Start menu.
2. Choose Control Panel, then double-click the System icon.
3. Choose the Device Manager tab, then click the “+” in front of SCSI
controllers. “Win98-ME Promise SATA150 TX Series Controller” should
appear.