User manual

SATA150 TX2plus, TX4 User Manual
4
Installing the SATA150 TX Series Card
The SATA150 TX Series Controller card fits into any available 32-bit PCI slot
(must be PCI 2.2 or 2.3 compliant). It also fits the 32-bit portion of a 64-bit PCI
slot, on the system’s motherboard (see figure below).
1. Remove the cover of your system.
2. Remove the inside slot cover of an available 32-bit PCI slot on the
motherboard.
3. Install the SATA150 TX Series Controller card into the open slot (see Figure
1 below). Secure the bracket to the system’s frame.
4. Attach your system case’s 2- or 4-pin LED cable to the LED connector on
the SATA150 TX Series Controller card (see Figures 2 and 3, below). Make
sure that pin 1 on the connector is aligned with pin 1 of the cable.
5. Fasten the controller card bracket to the system case (see below).
Figure 1.
Insert the SATA150 TX Series card into an open PCI slot.