Product manual

Chapter 4: Management with WebPAM PROe
101
Restarting Email Service
To restart the Email service:
1. Click the AdminTool tab.
2. Click the Services icon.
3. Mouse-over the Email service and click the Restart button.
Making Email Settings
To change Email service settings:
1. Click the AdminTool tab.
2. Click the Services icon.
3. Mouse-over the Email service and click the Settings button.
4. Make settings changes as required:
• Choose a startup type,
• Automatic – (default) Starts and runs with the subsystem.
• Manual – You start the service when you need it.
• SMTP Server IP address.
• SMTP Authentication – The Yes option enables authentication.
The No option disables.
• SMTP Authentication Username – Required if SMTP authentication is
enabled.
• SMTP Authentication Password – Required if SMTP authentication is
enabled.
• Email Sender (From) Address – The sender’s name shown on
notification messages.
• Email Subject – The subject line of the notification message.
5. Click the Save button.
6. Click the Confirm button.
SLP Service
Service Location Protocol (SLP) discovers services over the Internet. SLP
applies to IPv4 protocol only.
Note
To verify your settings, send a test message.