Product manual

Chapter 4: Management with WebPAM PROe
103
4. Click the Confirm button.
To start the Webserver service after stopping it:
1. Click the AdminTool tab.
2. Click the Services icon.
3. Mouse-over the Webserver service and click the Start button.
Restarting Webserver Service
1. Click the AdminTool tab.
2. Click the Services icon.
3. Mouse-over the Webserver service and click the Restart button.
Making Webserver Settings
To change Webserver service settings:
1. Click the AdminTool tab.
2. Click the Services icon.
3. Mouse-over the Webserver service and click the Settings button.
4. Make settings changes as required:
• Choose a startup type,
• Automatic – (default) Starts and runs with the subsystem.
• Manual – You start the service when you need it.
• Session Time Out – Default is 24 minutes.
• HTTP Port number – Default is 80.
• Enable SSL – Security protocol used with HTTPS.
Default is enabled (checked).
• HTTPs Port number – Default is 443.
5. Click the Save button.
6. Click the Confirm button.
Telnet Service
Telnet service enables you to access the RAID subsystem’s Command Line
Interface (CLI) through a network connection.
Stopping Telnet Service
To stop the Telnet service:
1. Click the AdminTool tab.
2. Click the Services icon.
3. Mouse-over the Telnet service and click the Stop button.