Product manual

Chapter 5: Management with the CLU
187
3. Highlight Media Patrol and press the spacebar to toggle between Enable
and Disable.
4. Highlight PDM and press the spacebar to toggle between Enable and
Disable.
5. Highlight Power Management and press the spacebar to toggle between
Enable and Disable.
6. Press Ctrl-A to save your settings.
See “Running PDM” on page 188 and “Making Background Activity Settings” on
page 208.
For Power Management settings, see “Making Controller Settings” on page 167.
Preparing the Disk Array for Transport
To run the Transport function on a disk array:
1. From the Main Menu, highlight Disk Array Management and press Enter.
2. Highlight the disk array you want and press Enter.
3. Highlight Transport and press Enter.
4. Press Y to confirm.
Rebuilding a Disk Array
Before you can rebuild, you must have a replacement or target physical drive of
adequate capacity for your disk array.
To rebuild a disk array:
1. From the Main Menu, highlight Disk Array Management and press Enter.
2. Highlight the disk array you want and press Enter.
3. Highlight Background Activities and press Enter.
4. Highlight Rebuild and press Enter.
Default source and target drives are shown with possible alternative choices.
5. To choose different drive, highlight the drive, press the backspace key to
remove the current number, then type a new number.
6. Highlight Start and press Enter.
For rebuild rate, see “Making Background Activity Settings” on page 208.
Migrating a Disk Array
In order to migrate RAID level, you may have to add physical drives. For more
information, see “RAID Level Migration” on page 275.