Product manual

Chapter 5: Management with the CLU
225
2. Highlight Software Management and press Enter.
3. Highlight SNMP and press Enter.
4. Highlight Trap Sinks and press Enter.
5. Highlight Create New Trap Sink and press Enter
6. Highlight Trap Sink IP address and press the backspace key to erase the
current value, then type the new IP address in this field.
7. Highlight Trap Filter and press the spacebar to toggle through the severity
levels.
See Table 3 on page 225.
8. Press Ctrl-A to save the Trap Sink.
Deleting a Trap Sink
To delete a trap sink:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Software Management and press Enter.
3. Highlight SNMP and press Enter.
4. Highlight Trap Sinks and press Enter.
5. Highlight the trap sink you want to delete and press the spacebar to mark it.
The mark is an asterisk (*) to the left of the listing.
6. Highlight Delete Marked Entries and press Enter.
Table 3 Event severity levels
Making CIM Settings
By default, Common Information Model (CIM) service is set to Automatic and its
normal status is Started.
Level Meaning
Fatal Non-Recoverable error or failure has occurred
Critical Action is needed now and the implications of the condition are
serious
Major Action is needed now
Minor Action is needed but the condition is not a serious at this time
Warning User can decide whether or not action is required
Information Information only, no action is required