Product manual

VTrak E-Class Product Manual
250
Replacing a Power Supply
The power supply and its fans are replaced as one unit. There are no individually
serviceable parts. No tools are required for this procedure.
E830f and E630f
Removing the Old Power Supply
To remove the power supply:
1. Verify that the status LED is amber or red. See Figure 2.
2. Switch off the power.
3. Unplug the power cord.
4. Turn the two set screws counter-clockwise to loosen them.
The screws are retained on the power supply housing.
5. Grasp the handle and pull the power supply out of the enclosure.
Figure 2. Power supply for VTrak E830f and E630f
Installing a New Power Supply
To install the power supply:
1. Carefully slide the power supply into the enclosure.
2. Turn the two set screws clockwise to tighten them.
3. Plug in the power cord.
4. Switch on the power supply.
5. Verify that the new power supply LED is green. See Figure 2.
Status
LED
On/Off
Switch
Set screw
Set screw
Handle