Product manual

Chapter 6: Maintenance
255
Figure 5. RAID controllers
Installing the New Controller
To install the new RAID controller:
1. Carefully slide the RAID controller into the enclosure.
2. Gently swing the handle in and press the handle until it locks.
3. Reconnect all cables that were attached to the RAID controller,
If one of the controllers goes into maintenance mode, see “Maintenance
Mode” on page 312.
• Fibre Channel cables
• SAS cable
• Ethernet (management) cables
• Serial cable
• USB cable
• UPS control cable
Release tab and handle
VTrak E830f and E630f
VTrak E330f
Release tab and handle