Product manual

VTrak E-Class Product Manual
258
Resetting the Default Password
This feature resets the Administrator’s password to the default factory setting,
password. Use this feature when you have forgotten Administrator’s password
or a new Administrator has been appointed.
The reset applies to the Administrator’s login for WebPAM PROe, the CLI, and
the CLU. No other user passwords are affected.
To reset the Administrator’s default password:
1. Verify that the VTrak has fully booted.
See page 33 or page 295 for more information.
2. For one of the RAID controllers, locate the password reset switch.
See Figure 6.
3. Insert a pin or a straightened paper clip into the opening and momentarily
depress password reset switch.
You only need to press the reset switch on one RAID controller.
Figure 6. FC RAID controller password reset
The next time the Administrator logs in, use the default password, password.
For more information, see “Logging into WebPAM PROe” on page 51 and
“Logging Into the CLI” on page 158.
Important
PROMISE recommends that you change the Administrator’s
default password immediately after reset. See “Changing User
Passwords” on page 87 or page 219.
Password reset switch