Product manual

VTrak E-Class Product Manual
296
See the table below.
See “Enclosure Problems” on page 308, “Controller Problems” on page 312, and
“Disk Array and Logical Drive Problems” on page 317 for more information.
The Locator feature is triggered from WebPAM PROe or the CLU. It causes the
LEDs to blink on and off for one minute. That action helps you find the physical
component.
Drive Carrier LEDs
The VTrak spins up the disk drives sequentially to equalize power draw during
start-up. After a few moments:
The Power/Activity LED displays blue when a physical drive is present.
The Drive Status LED displays green when the physical drive is configured
as a member of a disk array or as a spare. When the physical drive is
unconfigured, the LED is dark.
See the diagram and table on the next page.
Enclosure Front LEDs
State Power FRU
Logical
Drive
Controller
Activity
Controller
Heartbeat
Dark No power No power No Activity
Steady
Green
Normal Normal Normal
Blinking
Green
————Normal**
Flashing
Green
Activity
Amber Problem* Critical
Red Failure* Offline
* Check the LEDs on the back of the VTrak enclosure.
** Blinks blinks green once per second for five seconds, goes dark for ten
seconds, then blinks green once per second for five seconds again.