Product manual

Mounting VTrak in a Rack
15
Mounting VTrak E830f/s and E630f/s in a Rack
The VTrak subsystem installs into your rack using the supplied mounting rails.
Figure 1. VTrak E630f/s mounted in a rack with the supplied rails
To install the VTrak subsystem into a rack with the supplied mounting rails:
1. Check the fit of the mounting rails in your rack system.
See page 16, Figure 2.
2. Adjust the length of the mounting rails as needed.
The rear rail slides inside the front rail. The rail halves are riveted together
and use no adjustment screws.
3. Attach the mounting rail assemblies to the outside of the rack posts, using
the attaching screws and flange nuts from your rack system.
Be sure the front rail support is on the bottom facing inward.
The alignment pins fit into the rack holes above and below the attaching
screws.
Use the attaching screws and flange nuts from your rack system. Tighten the
screws and flange nuts according to your rack system instructions.
4. Place the VTrak subsystem onto the rails.
5. Secure the VTrak subsystem to the rack.
Use the attaching screws and flange nuts from your rack system, one set
each side. Tighten the screws and flange nuts according to your rack system
instructions.
VTrak E630f/s
Mounting rails (included)
mount outside the rack post
Handles mount
outside the rack post
Vertical Rack Post
Attaching screw & flange nut
one each side