Product manual

Mounting VTrak in a Rack
17
Attaching the Sliding Plates
To install the side plates onto VTrak subsystem:
1. Slide the plates out of the mounting rails.
2. Attach one plate to each side of the VTrak subsystem.
Line-up the six holes in the plate with the corresponding holes in the
subsystem. Attach each plate with six screws (included). See Figure 4.
Figure 4. VTrak E330f/s sliding flange installation
Installing the Subsystem into the Rack
To install the VTrak subsystem into a rack with the supplied mounting rails:
1. Check the fit of the mounting rails in your rack system. See page 18,
Figure 5.
2. Slide one of the rails over the plate on one side of the enclosure.
The rail is designed to slide freely over the plate.
3. Attach a flange to each end of the rail, with the rail on the opposite side of the
flange from the two-hole bracket.
4. Install the rail adjustment screws (included) through the flange into the rail.
There are four screws for each flange. See page 19,
5. Place the subsystem with mounting rails into your rack system.
6. Attach the mounting rail assemblies to the outside of the rack posts, using
the attaching screws from your rack system.
Sliding plate
VTrak E330f/s
Screws (6 each side)
Rear (connector end)
of the subsystem