Product manual

VTrak E-Class Product Manual
22
Figure 11.Drive carrier side view
6. Insert the screws through the proper holes in the carrier and into the drive or
adapter.
• Use the screws supplied with the VTrak or the SAS-to-SATA adapter.
• Install four screws per drive.
• Install two screws per adapter.
• Snug each screw. Be careful not to over tighten.
7. With the drive carrier handle in open position, gently slide the drive carrier
into the enclosure.
Important
• Press the release button to push the drive carrier into
position. Do not push the handle. See page 21, Figure 9.
• Proper drive installation ensures adequate grounding and
minimizes vibration. Always attach the drive to the carrier with
four screws.
3.5-inch SAS drive mounting holes (two each side)
3.5-inch SATA drive mounting holes (two each side)
drive carrier handle