Product manual

Chapter 3: Setup
37
If you choose to enable DHCP, have your Network Administrator dedicate an IP
address for the VTrak, linked to the VTrak’s MAC address. This action prevents
the DHCP server from assigning a new IP address when the VTrak restarts, with
the result that users can no longer log in.
To access the MAC address for VTrak’s virtual management port:
• In the CLI, type net -v and press Enter.
• In the CLU Main Menu, highlight Network Management and press Enter.
Then highlight Virtual and press Enter.
VTrak Default IP Addresses
VTrak uses virtual and physical IP addresses. This arrangement enables you to
access a VTrak with two RAID controllers over your network using a single IP
address.
Virtual Management Port
The default virtual management port IP address is set to 10.0.0.1.
The virtual management port IP address belongs to the VTrak subsystem, not to
the RAID controller. Use the virtual management port IP address to log into the
VTrak over your network.
See “Logging into WebPAM PROe” on page 42.
Physical Management Ports
The default physical management port IP addresses are set to:
• Controller 1 – 10.0.0.2
• Controller 2 – 10.0.0.3
The physical management port IP address belongs to the RAID controller, not to
the VTrak subsystem. Use the physical management port IP address only when a
controller is in maintenance mode.
Setting up VTrak with the CLI
1. Type the following string to set the system date and time, then press Enter.
administrator@cli> date -a mod -d 2009/06/25 -t 14:50:05
In the above example, the date and time are included as examples only. Use
yyyyy/mm/dd for the date and a 24-hour clock for the time.
2. Type the following string to set the Virtual Management Port IP address and
other settings, then press Enter.
administrator@cli> net -a mod -t mgmt -s "primaryip=192.168.10.85,
primaryipmask=255.255.255.0, gateway=192.168.10.1"