User manual

FastTrak TX2000™ Series User Manual
9
Checking CMOS Settings
No changes are necessary in the Motherboard CMOS Setup for resources or drive types. Since
FastTrak TX2000 is a PCI Plug-n-Play (PnP) device, the Interrupt and Port address resources
are automatically assigned by the Motherboard's PCI
PnP BIOS.
The FastTrak TX2000 system resources including port address, interrupt, and BIOS address
are automatically determined by the system PnP BIOS. To customize
IRQ settings, enter the Motherboard BIOS's Advanced PCI setup and follow the manufacturer's
procedures. If the system has limited IRQ resources, the FastTrak TX2000 card can be set for
the same IRQ as other PCI cards if those cards support PCI interrupt sharing.
If you wish to boot from a FastTrak TX2000 drive array AND continue to use hard drives
attached to your motherboard's IDE controller, refer to your motherboard manual for the specific
BIOS settings to use in order to establish their proper boot order.