User manual

FastTrak TX2000™ Series User Manual
31
Installing Driver in Existing Windows XP System
WARNING: If you will be moving the boot drive containing the existing Windows
XP operating system to the FastTrak TX2000 card, the FastTrak TX2000 driver
MUST be loaded on to this hard drive while it is still attached to your existing hard
drive controller. Do not attach this drive or any other hard drive to the FastTrak
TX2000 controller card before completing this step.
After installing the FastTrak TX2000 card and rebooting your system, Windows XP setup will
show a “Found New Hardware” dialog box. Under Windows XP, “Mass Storage Controller” will
be displayed.
1. In the A:\ drive, insert the FastTrak TX2000 driver diskette.
2. Choose “Install the software automatically” and press the “Enter” key.
3. Choose “WinXP Promise FastTrak TX2000 (tm) Series Controller” from the list that
appears on screen, and then press the “Enter” key.
4. If using a driver that has not been digitally signed by Microsoft, you will be asked if
you want to continue the installation. Click on “Continue anyway”.
5. When the New Hardware Wizard has finished installing the Promise Ultra ATA 133
software, click on “Finish”
Confirming Windows XP Installation
1. From Windows XP, open the Control Panel from “My Computer”.
2. Click on “Performance and maintenance”.
3. Click on the “System” icon.
4. Choose the “Hardware” tab, and then click the “Device Manager” tab.
5. Click the “+” in front of “SCSI controllers”. “WinXP Promise FastTrak TX2000 (tm)
Series Controller” should appear.