User manual

FastTrak TX2000™ Series User Manual

3. Choose the “Device Manager” tab, and then click the “+” in front of “SCSI & RAID

controllers.” “Win9x-ME Promise FastTrak TX2000 (tm) Series Controller” should

appear.

DOS/Windows 3.1x

For first-time installation, follow the standard procedure of installing DOS on to your hard disk

(partition all hard drives with FDISK and format before performing the following procedure):

1. Insert “Disk 1” of your DOS installation diskettes into drive A:.

2. Type “A:SETUP” at the “A:\” prompt.

3. Continue with normal DOS installation procedure, and refer to your DOS manual for

additional details.

NOTE: The FastTrak TX2000 BIOS supports both DOS and Windows 3.1x without software

drivers.