FastTrak TX Series User Manual

Chapter 4: FastBuild™ Utility

See “Introduction to RAID” on page 91 for more information.

4. Press the arrow keys to move to the next option. Option choices depend on

the RAID Level you selected.

• Fast Init erases the Master Boot Record (MBR) of the disk drives when

this feature is set to ON.

• Stripe Block Size. Press the Spacebar to toggle through 32 KB, 64 KB,

or 128 KB. 64 KB is the default. Applies to RAID 0.

5. Press the arrow keys to move to Disk Assignments. Press the spacebar to

toggle between N and Y for each available drive. Y means this disk drive will

be assigned to the logical drive.

Assign the appropriate number of disk drives to your logical drive.

6. Press Ctrl-Y to save your logical drive configuration.

7. If you set Fast Init to ON, the following message displays:

• Press Ctrl-Y to continue logical drive creation and perform the Fast

Initialization.

• Press any other key to cancel logical drive creation.

If you set Fast Init to OFF, the following message displays:

Press N to finish logical drive creation.