Product manual

Chapter 2: VessRAID Installation
21
Management Path
The VessRAID controller has one (1) Ethernet RJ-45 Management Port
connector. See page 21, Figure 9.
To establish the management path:
1. Attach one end of an Ethernet cable to the network connector or standard
NIC in the Host PC.
Attach the other end of the Ethernet cable to one of the ports on the standard
network switch.
See page 22, Figure 10.
2. Attach one end of an Ethernet cable to one of the ports on the standard
network switch.
Attach the other end of the Ethernet cable to the Management Port on the
VessRAID subsystem.
If you have multiple VessRAID subsystems, Host PCs or Servers, repeat
steps 1 and 2 as required.
Figure 9. VessRAID 1840f+ data and management ports. 1840f is similar
iSCSI data port 1
Management port
iSCSI data port 2
FC data port 2
FC data port 1
SAS Expansion
port (to JBOD)