Network Hardware User Manual

Step 6: Connecting the Power

Plug the power cords and switch on both power supplies on. When the power is

switched on, the LEDs on the front of the VTrak will light up.

Figure 22.VTrak E310f/s front panel LED display

When boot-up is finished and the VTrak is functioning normally:

• Controller LED blinks green once per second for five seconds, goes dark for

ten seconds, then blinks green once per second for five seconds again.

• Power, FRU and Logical Drive LEDs display green continuously.

• Controller LEDs flash green if there is activity on that controller.

There are two LEDs on each Drive Carrier. They report the presence of power

and a disk drive, and the current condition of the drive.

Figure 23.VTrak E310f/s disk carrier LEDs

After a few moments the Power/Activity should display Green. If there is no disk

drive in the carrier, the Power/Activity LED will remain dark.

Power

Controller-2 Activity

FRU Status

Logical Drive Status

Controller-1 Activity

Controller Heartbeat

Disk Status

Power/Activity