Product manual

Chapter 5: Management with the CLU
251
• Subnet Mask
• Default Gateway IP Address
• DNS Server IP Address
6. Press Control-A to save your settings.
Making Maintenance Mode Settings
Each controller has its own IP addresses for access when the controller goes into
maintenance mode. For more information, see “Maintenance Mode” on
page 395.
Before you change settings, please see “About IP Addresses” on page 45.
Making Automatic Settings
1. From the Main Menu, highlight Network Management and press Enter.
2. Highlight Maintenance Mode Network Configuration and press Enter.
3. Highlight the controller (CId 1 or 2) and protocol family (IPv4 or IPv6) you
want and press Enter.
4. Highlight DHCP and press the spacebar to toggle to Enabled.
5. Press Control-A to save your settings.
Making Manual Settings
1. From the Main Menu, highlight Network Management and press Enter.
2. Highlight Maintenance Mode Network Configuration and press Enter.
3. Highlight the controller (CId 1 or 2) and protocol family (IPv4 or IPv6) you
want and press Enter.
4. Highlight DHCP and press the spacebar to toggle to Disabled.
5. Highlight each of the following and press the backspace key to erase the
current value, then type the new value.
• IP Address
• Subnet Mask
• Default Gateway IP Address
• DNS Server IP Address
6. Press Control-A to save your settings.