Product manual

VTrak E-Class Product Manual
328
Removing the Old Controller
To remove the RAID controller:
1. Shutdown the VTrak. See “Shutting Down the Subsystem” on page 83
(WebPAM PROe) or page 307 (CLU).
2. Switch off the power.
3. Disconnect all attached cables from the RAID controller,
4. On the controller handle, squeeze the release tab and pull the handle
outward. See page 327, Figure 4.
5. Pull the RAID controller out of the subsystem enclosure.
Installing the New Controller
To install the new RAID controller:
1. Carefully slide the RAID controller into the enclosure.
2. Gently swing the handle in and press the handle until it locks.
3. Reconnect all cables that were attached to the RAID controller.
4. Turn on the power supply switches.
Important
Do not replace the RAID controller based on LED colors alone.
Only replace the RAID controller when directed to do so by
PROMISE Technical Support. See page 435.
Important
The firmware on the replacement RAID controller must be the
same version as the original RAID controller or a later version.
The amount of SDRAM in the replacement RAID controller must
be the same as the original RAID controller or greater.
To obtain firmware and SDRAM information for the currently
installed RAID controller, click the Administration button then
click the Image Version icon.
• Fibre Channel cables
• iSCSI cables
• SAS expansion cables
• Management port cables
• Serial cable
• UPS control cable
• Fibre Channel cables
• iSCSI cables
• SAS expansion cables
• Management port cables
• Serial cable
• UPS control cable