Product manual

Chapter 8: Troubleshooting
415
Drive-interface diagnostics has passed No action is required.
Drive-interface diagnostics has failed Restart the VTrak. If this message
appears repeatedly, contact Tech
Support.
Drive-interface controller has generated
a general parity error
If this message appears repeatedly,
contact Tech Support.
Drive-interface controller has generated
a data parity error
Enclosure
Enclosure temperature is above the
threshold
Check blowers and fans.
Enclosure temperature is above the
warning threshold
Check airflow around the VTrak. Check
blowers and fans.
Enclosure temperature is above the
critical threshold
Enclosure temperature is within the
normal range
No action is required.
Shut down PSUs due to enclosure or
controller temperature over threshold
Shut down the VTrak and see
“Enclosure Problems” on page 391.
Event Log
Event logging is enabled
No action is required.
Event logging is disabled
Event log buffer is cleared in RAM
Event log buffer is cleared in NVRAM
Event log buffer is cleared in MDD
Fibre Channel
Fibre Channel controller has detected
bus reset
If this message appears repeatedly,
contact Tech Support.
Fibre Channel controller has received a
“LUN reset” command.
No action is required.
Fibre Channel controller has
encountered a fatal error
Restart the VTrak. If this message
appears repeatedly, contact Tech
Support.
Reported Event Corrective Action