Product manual

VTrak E-Class Product Manual
48
2. To verify the setting change, at the command prompt, type net and press
Enter. The following information displays:
administrator@cli> net
==========================================
PF Status IP Link
==========================================
IPv4 Enabled 192.168.10.85 Up
IPv6 Disabled 2001::1 Up
In the above example:
• PF refers to IP protocol family, v4 or v6
• Status refers to whether the IP protocol is enabled. IPv4 is enabled by
default.
• IP is the virtual management port IP address.
• Link indicates whether there is a working network connection.
By default, IPv4 is enabled and IPv6 is disabled. Currently IPv6 does not
suppport DHCP.
Making Virtual Management Port Settings – Manually under IPv4
To make IPv4 settings manually on the management port:
1. At the command prompt, type net -a mod -f ipv4 -s " followed by:
• primaryip= and the IP address ,
• primaryipmask= and the subnet mask ,
• primarydns= and the DNS server IP address ,
• gateway= and the Gateway server IP address
" and press Enter.
Example:
administrator@cli> net -a mod -f ipv4 -s "primaryip=192.168.10.85,
primaryipmask=255.255.255.0,primarydns=192.168.10.11,gateway=19
2.168.10.1"
After a moment, the comand prompt reappears, indicating that your setting
was successful.
administrator@cli>
2. To verify the settings, at the command prompt, type net -a list -v and press
Enter.
The following information displays:
administrator@cli> net -a list -v
-------------------------------------------------------------------------------
ActiveCtrlId: 1 Port: 1