Product manual

Chapter 3: Setup
57
Making Virtual Management Port Settings – Manually under IPv4
To make IPv4 settings manually on the management port:
1. Press the arrow keys to highlight IP Address.
2. Press the backspace key to erase the current IP address.
3. Type the new Management Port IP address.
4. Follow the same procedure to specify the Subnet Mask, Gateway IP
Address and DNS Server IP Address.
If you do not have a DNS server, skip the DNS Server IP address.
5. Press Control-A to save your settings and move to the Management Port
IPv6 settings screen.
Making Virtual Management Port Settings – Manually under IPv6
To make IPv6 settings manually on the management port:
1. Press the arrow keys to highlight IP Address.
2. Press the backspace key to erase the current IP address.
3. Type the new Management Port IP address.
4. Follow the same procedure to specify the Subnet Mask, Gateway IP
Address and DNS Server IP Address.
If you do not have a DNS server, skip the DNS Server IP address.
5. Press Control-A to save your settings and move to the Maintenance Mode
screens.
Maintenance Mode Settings
For information on maintenance mode, see page 395.
You have the option to make maintenance mode settings at a later time in
WebPAM PROe.
Under Quick Setup, maintenance mode settings are made in the following
sequence:
1. Controller 1, IPv4
2. Controller 1, IPv6
3. Controller 2, IPv4
4. Controller 2, IPv6
Making Maintenance Mode Settings – Automatically
Automatic settings require a DHCP server on your network. DHCP is currently
supported on IPv4 only.