Model:OSCFO2 Smart Ceiling Fan Manual
b Unpack your fan and check the contents. You should have the following items: c d a MED LOW LIGHT ON/OFF HI STOP l 2H 4H 1H 8H e a. b. c. d. e. f. g. h. i. Fan blades (3) Ceiling mounting bracket Canopy Canopy cover Ball/downrod assembly Coupling cover Fan housing Fan motor assembly Li ight plate m f g j. Led light kit k. Glass shade l. Hand held remote control system m. Receiver n.
. ATTACHING THE GSN BLADES Screw Step 1. Attach the blade to the flywheel using the screws with spring washer in the bag as shown in figure 5. Screw Star screw into flywheel.Repeat for the two remaining screws. Step 2. Repeat for the remaining blades. Step 3. Make sure the blade is straight and tighten each screws. Blades Fig 5 6. FAN HOUSING INSTALLASION Noted: Be sure must install the blades before installing the fan housing. Reinforcing piece Step 1.
7.HANGING THE FAN CUL Listed electrial box Ceiling mounting bracket Hook Washers 120V Wires Fig 8 Mounting screws (supplied with electrical box) Downrod Canopy Canopy cover Coupling cover bracket as shown in fig 8. Set screws Hitch pin Retaining clip through the ball/downrod.(Fig 9) Fig 9 the motor housing (fig.9).Carefully insert the position, as noted in the circle inset of Fig.9. Locating slot fan motor firmly.(Fig.9) bracket socket.(Fig.
8.ELECTRIC CONNECTIONS WARNING: To avoid possible electrical shock, be sure you have turned off the power at the main circuit panel. Follow the steps below to connect the fan to your household wiring. Use the wire connecting nuts suppled with your fan. Secure the connectors with electrical tape. Make sure there are no loose wire strands or connections. Receiver Step 1. Insert the receiver into the ceiling mounting bracket with the flat side of the receiver facing the ceiling. (Fig.
9. FINISHING THE INSTRUCTION Outlet box Ceiling mounting bracket Screws Screws Canopy Canopy cover Fig 13 Fig 13 10. INSTALLING THE LED LIGHT KIT AND LAMP SHADE NOTE: Before starting installation, disconnect the power by turning off the circuit breaker or removing the fuse at fuse box. Step 1. Loosen the three screws on the round plate and "remove" and save it for later use.(Fig.14) Step 2. Place the light pan onto the round plate and aligning the hole slots.
11. Operation for remote KINDLY REMINDERS: Learning code maching mode is useed between emitter and receiver,Turn "ON" the supply power within 30 seconds and press the emitter's "LI" and "Hi"button for 3 seconds, it can load normally after hearing the "BEE" which means learning successfully and it can works normally.(PS:Learing mode is not acepted after turn "ON" the supply power for 30 seconds) 1. speed control button of fan: HI. MED AND LOW are speed button. 2. LI :ON/OFF the lamp 3.
12.
QIACHIP Product Specifications Applications Operating Voltage Max Load Power Standby Power consumption Working temperature Control Method Wiring Method Light/Fan 110V/220V Depending on model <300WCeiling Fan/ <200WLED Light <0.
QIACHIP Mobile App Pairing Instructions: Step one: Initiate pairing status Initiate pairing status by Pressing LIGHT & HI together for at least 10 seconds until you hear along beep sound from the receive or the LED light switch off. Step two: Finishing the pairing progress in Mobile App a. Download and Open“ Smart Life ”Mobile App. b. Press the + button in the top right corner of the mobile App. c. Under Add“ Manually ”select Home Appliances. d. Select Fan. e.
