Instructions / Assembly

Fig 13
9. FINISHING THE INSTRUCTION
10. INSTALLING THE LED LIGHT KIT
AND LAMP SHADE
Fig 14
NOTE: Before starting installation, disconnect
the power by turning off the circuit
breaker or removing the fuse at fuse box.
Step 1. Loosen the three screws on
the round plate and "remove" and save
it for later use.(Fig.14)
Step 2. Place the light pan onto the
round plate and aligning the hole slots.
then re-install the screws which were
just removed. Tighten all screws securely.
(Fig.14)
Step 3 .While holding the LED light kit
under the fan motor, make the wire
connections:(Fig. 14)
Blue to Blue. White to White.
Step 4 . Raise the glass shade against
the LED light kit and turn clockwise
until snug(fig.14).
Then place the LED light kit onto the light
plate by magnet (Fig. 14)
DO
NOT OVER TIGHTEN.
Glass shade
Wire connectors
LED light kit
Screws
Light plate
8
Canopy cover
Fig 13
Canopy
ScrewsScrews
Ceiling mounting
bracket
Outlet box