Instruction Manual

Promystic Inside Out Instruction Manual 11
Active, Sleep, Deep Sleep, and LOCK Modes:
With a battery installed, the cube is always “on.” To conserve battery life, the cube has four
modes: active, sleep, deep sleep, and lock.
Active: When the cube is turned to a new side, it will transmit the code for that side ten times.
Sleep: After transmitting ten times, the cube will go to sleep. At this point it will transmit only if
turned to a new side. This approach not only preserves battery life, but also lets you continue
your routine without all the buzzing in your pocket. When a new side of the cube is selected,
the cube will go active within 4 seconds and transmit ten times.
Deep sleep: If the cube isn’t moved for about 10 minutes, it will go into deep sleep. The cube
sleeps for 30 seconds at a time, then briefly checks to see whether it has been turned to a new
side. If it detects a new side it will wake up. When the cube is turned, it will wake up within 30
seconds and go into the active state. When the cube is not in use, it stays in deep sleep to
conserve battery life.
Lock: In this mode the cube will not wake up until it receivers a special code. To put the cube to
sleep, dial the cube 1-2-3-4-5-6. You must enable the ‘Lock’ mode while installing the battery
to enable this feature. It is used to lock the cube off for travel with the cube. To unlock the
cube, turn the 6 side up. Wait for the ‘6’ signal and then dial a ‘1’ followed by a ‘6’.