Instructions / Assembly

METAL FRAME
Overshelf
Flange at
top of FRAME
Flange on
Overshelf
In the hardware bag, locate the six BLACK
SCREWS. Line the hole in the FRAME with
the hole in the side of the Overshelf. Screw
the BLACK SCREWS into the sides- one on
each side. Then screw in the four remaining
screws into the lower shelf through the
FRAME.
TACKBOARD
TACKBOARD
Take the TACKBOARD, and
slide it up under the upper
flange of the FRAME. Press it
into the FRAME, and slide it
down into the lower flange of the
FRAME, as shown.
Slide up
Press in
Slide down
PARTS LIST
QTY DESCRIPTION
(1) TACKBOARD (IN FRAME)
(1) METAL FRAME
HARDWARE BAG:
(6) BLACK SCREW (#10-24 X 1/2)
Your Tackboard is ready for use.
R05145 09/09/09
TACKBOARD ASSEMBLY
Remove the TACKBOARD from the
metal FRAME. Set the TACKBOARD
aside.
Align the metal FRAME with the
Overshelf as shown. The holes in the
flange at the top of the FRAME should
align with the holes in the flange of the
shelf.
Before assembly, make sure that you
have everything you need- check your
parts against the parts list at the bottom
of the page. If you are missing anything,
please call us at 1-800-621-8846.