Instruction manual

FRAME ASSEMBLY
WARNING
If you move the trampoline you must use a minimum of 2 people. Make sure the ground is level at the set up
location otherwise the tension of the springs might deform the frame.
We Recommend: That the Trampoline MUST be set up on grassed area only. Not suitable on concrete or other
hard surfaces.
WARNING: 2-3 adults in good physical condition are required for the following assembly. You MUST wear
closed in shoes and gloves. Make sure area around assembly area is clear of any hazards which may cause a
fall or loss of balance. Failure to follow all instructions and warnings exactly may result in serious injury.
Step 1
Lay out all trampoline parts in groups
(as shown in picture). Check, prior to
assembly, that all parts are complete
according to the parts list.
(Picture is used for display purposes
only)
Step 2
Insert the Leg Extension (Upright
Tube) into the Base Leg (W - tubes)
as shown in the picture.
Step3
Place the top rails with the spring slits
facing upward and connect them with
the T-tube connectors as shown.
Step4
Joining the last link may require two
adults with a third person holding
the opposite side. Bring both sides of
the circle firmly together. Please
compare your result with the above
picture.
Step 5
Lift up the frame on one side and
insert T-Tube into W-shaped / base
leg underneath. Repeat this step
around the circumference of the
trampoline. Note: 2 or more persons
are required to lift the frame on the
opposite side.
Step 6
Lay the jumping mat inside the frame as
per picture above