User Manual

ARRANGING IN THE SEQUENCER
173
Splitting clips
You can split clips using the Razor Tool in Arrange Mode. To split a single clip, proceed as follows:
1. Select the Razor Tool and place it where you want to split the clip.
On the Razor Tool’s left edge is a cross-hair which indicates where the split will take place. If activated, the Snap
setting is taken into account (see “Snap”).
2. Click with the Razor Tool to split the clip at the cross-hair’s position.
The clip is now split into two separate clips.
A vertical line appears where the clip is split
! Recordings and events in a split clip will always remain intact, e.g. notes in a note clip will not be split even if
they span over the split point.
It’s also possible to split clips on all tracks in a song:
1. Place the Razor Tool’s cross-hair on the Ruler where you want to split the clips on all tracks and lanes of the
song.
2. Click in the Ruler to split the clips on all tracks and lanes at the current position.
Clips on tracks and lanes - including tracks and lanes that might not be visible - on the Arrange Pane will also be
split.
You can also cut out a section of one or several clips in one go to:
1. Place the Razor Tool on the Arrange Pane background close to where you want to split the clips.
2. Click and drag with the Razor Tool to select the split section - on one or several lanes.
3. Release the mouse button to split the clips.
If you want to “cut” out a section of all clips on all tracks in the song, this can be done as follows: