User Manual

NOTE AND AUTOMATION EDITING
253
About drawing parameter automation events outside an open clip
If you draw parameter automation events outside the boundaries of an open clip, the same rules apply as when draw-
ing note events outside an open clip. See “About drawing notes outside an open clip”.
Deleting automation events
D Deleting automation events is done in the same way as when deleting note events. I.e. click on events to select
them or draw selection rectangles and then press [Backspace] or [Delete] - or use the Eraser tool (see “Delet-
ing notes”).
D To clear all automation events in a clip, hold down [Ctrl](Win) or [Cmd](Mac) and press [A] to select all events,
then press [Backspace] or [Delete]. Alternatively, delete the clip (or remove the whole lane to clear all automa-
tion for that parameter).
Editing performance controller automation
D To edit, draw or delete performance controller events, open the note clip in Edit Mode.
Performance controllers (Mod Wheel and Pitch Bend in the example above) are shown on separate Performance
Controller Edit Lanes at the bottom of the open note clip. The performance controller curves are also indicated in
the Clip Overview (top), and in the clip in the Song/Block View.
D You can edit performance controller events using the Selection (Arrow), Pencil and Eraser tools, just like when
editing parameter automation events in Edit Mode (see “Editing parameter automation in Edit Mode”).
Performance Controller
Edit Lanes