User Manual

THE MAIN MIXER
360
FX Return section
This section controls the master levels of the FX Returns. Send effect devices are connected to the Master Section
via the 8 FX Send and 8 FX Return connectors on the back of the rack device. See “Send FX” for a description of
Send FX.
The Send/Return connectors on the Master Section device.
You can monitor the Return bus via the Control Room output - see “Control Room output section”.
The section contains the following items:
Signal Path button If activated, the “Inserts Pre Compressor” button will place the Inserts before the Master Compressor in the signal
chain. If the Master Insert effects contain a maximizer or limiter, the inserts should normally be last (this button should
be off).
|
Parameter
|
Description
Level Adjusts the FX Return master level. The master return levels are normally left at default 0dB. if you wish to increase/de-
crease the effect balance, this is best done by increasing/decreasing the send levels for the individual channels using
the effect. You can, however, use the FX Return level to change the overall balance of a send effect in the mix.
Pan Pan adjusts the return signal stereo balance.
Meter Shows the signal level of the return bus.
EDIT button This brings the connected effect device in the rack into view for easy editing of its parameters.
Mute (M) This mutes the return signal for the send effect.
Name label This automatically shows the name of the connected effect device. If you enter a new name for the label, this overrides
the automatic naming. Deleting a manually entered name will bring back the automatic naming.
|
Parameter
|
Description