User Manual

THOR POLYSONIC SYNTHESIZER
(RECORD+REASON)
588
Scale parameters
The available scale parameters are the same as the Source parameters.
About using the Audio inputs
The 4 Audio inputs on the back panel can be used to connect external audio sources and process them with Thor’s
parameters.
Note that when routing audio to the Voice section, the following things apply:
• There are only mono inputs in the Voice section.
• You need to send a gate trigger for the audio signal to be heard. This can be done in three ways; by playing
notes, via notes played by the Step sequencer or from CV gate signals.
D Routing audio to Global destinations does not require a gate trigger and stereo inputs are provided.
D The external audio sources can also be used purely for modulation, e.g. you can modulate an oscillators pitch
with an audio signal.
This way you can use the audio input source to modulate any available destinations.
Delay The Delay effect has the following destinations:
•DryWet balance
•Time
•ModRate
•ModAmount
• Feedback
Step Sequencer This allows you to control various parameters belonging to the Step Sequencer.
• Trig - this enables control over the Step Sequencer Run on/off status.
• Rate - this enables control over the Step Sequencer Rate.
• Transpose - this enables control over the Step Sequencer base pitch.
E.g. if you apply MIDI Note as a source to this parameter you can
transpose the sequence by playing notes.
• Velocity - this enables control over the Step Sequencer Velocity re-
sponse.
• Gate Length - this enables control over the Step Sequencer Gate
Length response.
CV Output 1-4 This will allow you to send signals to the CV outputs on the back of the device. Note that you
can send CV signals to audio outputs and vice versa.
Audio Output 1-4 This will allow you to send signals to the audio outputs on the back of the device. Note that
you can send CV signals to audio outputs and vice versa.
|
Parameter
|
Description