Manualshelf

User Manual

ManualsBrandsPropellerhead ManualsAudio SoftwareRecord 1.5 PC / MAC - AUDIO PRODUCTION SOFTWARE
581582583584585586587588589590
Table Of Contents
THOR POLYSONIC SYNTHESIZER
(RECORD+REASON)
590
Setting the direction
The Direction parameter is used to set the direction of the step sequence. The following options are available:
D Forward - plays the sequence from the first step to the last.
D Reverse - plays the sequence from the last step to the first.
D Pendulum 1 - plays the sequence from the first step to the last, then from the last step to the first.
I.e. the last and first step is played twice when the sequencer reverses direction.
D Pendulum 2 - plays the sequence from the first step to the last, then from the second last step to the first, i.e.
without repeating the last/first step when reversing direction.
D Random - plays the steps in a random order.
Programming step note pitch
To program step note pitch, you proceed as follows:
1. Make sure that the Step Seq Trigger button is activated in the Controller panel.
2. Set the Run mode to “Repeat”.
You don’t have to use Repeat mode but it makes it easier to follow the following steps.
3. Start the step sequencer by pressing the Run button.
You should now hear a sequence of repeated notes, each with the same pitch (C3). The current step is indicated
by a yellow LED above the step buttons.
4. Make sure that the Edit knob is set to Note.