User Manual

NN-XT SAMPLER
(RECORD+REASON)
656
Whenever two or more selected zones have conflicting parameter settings, NN-XT will notify you about this by show-
ing a small “M” (for multiple) symbol, next to the parameter.
In this example, Level and Spread have conflicting settings.
D The controls on the panel always show the setting for the zone with edit focus.
D By clicking your way through the zones within the selection, you can see the settings for each zone.
D If you adjust a parameter, all selected zones will be set to the same value for this parameter.
You can put this functionality to good use when checking how a patch has been created and when checking that
your own settings are consistent through the various zones.
Sample parameters
The Sample parameters allow you to specify various properties for one or several selected zones, such as tuning, key
and velocity ranges.
D To set several zones to the same value, select them and adjust the parameter.
All zones will be set to the same value for the parameter you adjusted.
Copying parameters between zones
You can easily copy parameter settings from one zone to any number of other zones. Proceed as follows:
1. Select all the zones you want to involve in the operation.
By this we mean the zone with the settings you wish to copy, and the zone(s) to which you want to copy the set-
tings.
2. Make sure the zone that contains the settings you want to copy has edit focus.
3. Pull down the Edit menu or the NN-XT context menu and select “Copy Parameters to Selected Zones”.
All the selected zones will now get the exact same parameter settings.
! Observe that this only applies to the synth parameters (see “Synth parameters”). Sample parameters (root
key, velocity range etc.) can not be copied.